Configuring The Replacement Adapter - HP NetServer AA 6200 Administrator's Manual

Configuring the Replacement Adapter

To configure a replacement adapter:
Step Action
1 From My Network Places on the
desktop, select Properties to verify that
the network bindings are properly
configured.
2 Using the Endurance Manager:
• Enable the IOP.
• Make sure that any components
affected by this procedure are active
or online. Reenable any faulted or
disabled components
3 • Review the event logs for indications
of any problems.
• Review the procedure you followed
to ensure that you performed it
correctly. Repeat the procedure if
necessary.
• If the IOP is still not operating
properly, mirror copies have not
started, or any redirected Ethernet
connections are not in the standby
state, contact your service provider
for assistance.
9-24
Notes
• Verify and correct the adapter bindings to
match those in the other IOP. Refer to
Chapter 3
Installation Guide
to configure bindings.
• Correct the MAC addresses to the new
addresses, and then commit the Endurance
configuration.
If the IOP is now active, the mirror copies have
started, and all redirected Ethernet connections
are in standby, you have completed the
procedure.
If the above conditions are not met, proceed to
Step 3.
(page 9-31).
in the HP Netserver AA Solution
for information about how
HP Netserver AA Solution Administrator's Guide