Running MTCFLASH
Before you run MTCFLASH, note that:
•
In an Endurance server, all MICs (CE and IOP) must use the same MIC firmware
revisions.
•
After running MTCFLASH, you must reboot the computer that you are updating, either
by using the reset button or by powering the machine off and then on again.
Warning: Before removing power to any computer, observe all necessary
•
To run MTCFLASH on a CE, make sure that a keyboard is physically attached to the CE,
or select a CE port if you are using a KVM switch.
•
You must create an MTC diskette (described on
CD. For example, consider the following when creating an MTC diskette:
Table 7-2 Creating the MTC Diskette for Running MTCFlash
If running MTCFLASH . . .
When initially installing an
Endurance server
7-8
precautions to maintain Endurance server availability.
Create the MTC Diskette . . .
Using the Endurance CD that was
shipped with your Endurance server or
an Endurance hotfix diskette if one is
applicable to this release.
page
7-15) using the correct Endurance
HP Netserver AA Solution Administrator's Guide
Notes
Refer to the HP
Customer Support
web site for
information about
hotfixes that might be
applicable to your
release.