Snmp-Agent Sys-Info Contact - HP 6125XLG Command Reference Manual

Usage guidelines
The snmp-agent source command enables the SNMP agent to use the primary IP address of an interface
as the source IP address in all its SNMP informs or traps, regardless of their outgoing interfaces. An NMS
can use this IP address to filter all the informs or traps sent by the SNMP agent.
Make sure the specified interface has been created and assigned a valid IP address. The configuration
will fail if the interface has not been created and will take effect only after a valid IP address is assigned
to the specified interface.
Examples
# Configure the primary IP address of Ten-GigabitEthernet 1/1/5 as the source address of SNMP traps.
<Sysname> system-view
[Sysname] snmp-agent trap source ten-gigabitethernet 1/1/5
# Configure the primary IP address of Ten-GigabitEthernet 1/1/6 as the source address of SNMP
informs.
<Sysname> system-view
[Sysname] snmp-agent inform source ten-gigabitethernet 1/1/6
Related commands
display snmp-agent community
•
snmp-agent target-host
•
snmp-agent trap enable
•

snmp-agent sys-info contact

Use snmp-agent sys-info contact to configure the system contact.
Use undo snmp-agent sys-info contact to restore the default contact.
Syntax
snmp-agent sys-info contact sys-contact
undo snmp-agent sys-info contact
Default
No system contact is configured.
Views
System view
Predefined user roles
network-admin
Parameters
sys-contact: Specifies the system contact, a string of 1 to 200 characters.
Usage guidelines
Configure the system contact for system maintenance and management.
Examples
# Configure the system contact as Dial System Operator # 27345.
<Sysname> system-view
101