Display Debugging; Ping - HP 6125XLG Command Reference Manual

display debugging

Use display debugging to display the enabled debugging functions.
Syntax
display debugging [ module-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
module-name: Displays the debugging settings of the specified module. To display the current module
name, use the display debugging ? command.
Examples
# Display all enabled debugging functions.
<Sysname> display debugging
DEV debugging switch is on
Related commands
debugging

ping

Use ping to verify whether the destination IP address is reachable, and display related statistics.
Syntax
ping [ ip ] [ -a source-ip | -c count | -f | -h ttl | -i interface-type interface-number | -m interval | -n | -p
pad | -q | -r | -s packet-size | -t timeout | -tos tos | -v | -vpn-instance vpn-instance-name ] * host
Views
Any view
Predefined user roles
network-admin
Parameters
ip: Distinguishes between a destination host name and the ping command keyword. For example, you
must use the command in the form of ping ip ip instead of ping ip if the destination host name is ip.
-a source-ip: Specifies the source IP address of an ICMP echo request. It must be an IP address configured
on the device. If this option is not specified, the source IP address of an ICMP echo request is the primary
IP address of the outbound interface of the request.
-c count: Specifies the number of times that an ICMP echo request is sent. The count argument is in the
range of 1 to 4294967295. The default value is 5.
-f: Discards packets larger than the MTU of an outbound interface, which means the ICMP echo request
is not allowed to be fragmented.
6