Mirroring-Group Monitor-Egress - HP 6125XLG Command Reference Manual

[Sysname] mirroring-group 2 mirroring-port ten-gigabitethernet 1/1/6 both
Related commands
mirroring-group

mirroring-group monitor-egress

Use mirroring-group monitor-egress to configure an egress port for a remote source group.
Use undo mirroring-group monitor-egress to remove the egress port of a remote source group.
Syntax
In system view:
mirroring-group group-id monitor-egress interface-type interface-number
undo mirroring-group group-id monitor-egress interface-type interface-number
In interface view:
mirroring-group group-id monitor-egress
undo mirroring-group group-id monitor-egress
Default
No egress port is configured for a mirroring group.
Views
System view, interface view
Predefined user roles
network-admin
Parameters
group-id: Number of the mirroring group, in the range of 1 to 4. The mirroring group specified by
group-id must already exist.
interface-type interface-number: Specifies a port to be configured as the egress port by its type and
number.
Usage guidelines
You can configure an egress port only for a remote source group, but not for a local mirroring group or
remote destination group.
To make sure port mirroring works properly, disable the following functions on the egress port: the
spanning tree feature, 802.1X, IGMP snooping, static ARP, and MAC address learning.
Do not configure a port of an existing mirroring group as an egress port.
Examples
# Create remote source group 1, and configure port Ten-GigabitEthernet 1/1/5 as its egress port in
system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress ten-gigabitethernet 1/1/5
# Create remote source group 2, and configure port Ten-GigabitEthernet 1/1/6 as its egress port in
interface view.
193