Ntp-Service Unicast-Peer - HP 6125XLG Command Reference Manual

If you have specified the source interface for NTP messages in the ntp-service unicast-server or
•
ntp-service unicast-peer command, the interface specified in the ntp-service unicast-server or
ntp-service unicast-peer command serves as the source interface for NTP messages.
• If you have configured the ntp-service broadcast-server or ntp-service multicast-server command,
the source interface for the broadcast or multicast NTP messages is the interface configured with the
respective command.
If the specified source interface is down, the device searches the routing table for the outbound
•
interface, and uses the primary IP address of the outbound interface as the source IP address for
NTP messages.
Examples
# Specify the source interface for NTP messages as VLAN-interface 1.
<Sysname> system-view
[Sysname] ntp-service source vlan-interface 1

ntp-service unicast-peer

Use ntp-service unicast-peer to specify a symmetric-passive peer for the device.
Use undo ntp-service unicast-peer to remove the symmetric-passive peer specified for the device.
Syntax
ntp-service unicast-peer { ip-address | peer-name } [ vpn-instance vpn-instance-name ]
[ authentication-keyid keyid | priority | source interface-type interface-number | version number ] *
undo ntp-service unicast-peer { ip-address | peer-name } [ vpn-instance vpn-instance-name ]
Default
No symmetric-passive peer is specified for the device.
Views
System view
Predefined user roles
network-admin
Parameters
ip-address: Specifies an IP address of the symmetric-passive peer. It must be a unicast address, rather
than a broadcast address, a multicast address or the IP address of the local clock.
peer-name: Specifies a host name of the symmetric-passive peer, a case-insensitive string of 1 to 253
characters.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN to which the symmetric-passive peer belongs,
where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the symmetric-passive peer is
on the public network, do not specify this option.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP messages to the peer, where
keyid is in the range of 1 to 4294967295. If this option is not specified, the local device and the peer do
not authenticate each other.
priority: Specifies the peer specified by ip-address or peer-name as the first choice under the same
condition.
44