Info-Center Loghost Source - HP 6125XLG Command Reference Manual

Syntax
info-center loghost [ vpn-instance vpn-instance-name ] { ipv4-address | ipv6 ipv6-address } [ port
port-number ] [ facility local-number ]
undo info-center loghost [ vpn-instance vpn-instance-name ] { ipv4-address | ipv6 ipv6-address }
Default
No log host is specified.
Views
System view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN by its name, a case-sensitive string of 1 to 31
characters. If the log host is on the public network, do not specify this option.
ipv4-address: Specifies the IPv4 address of a log host.
ipv6 ipv6-address: Specifies the IPv6 address of a log host.
port port-number: Specifies the port number of the log host, in the range of 1 to 65535. The default is 514.
It must be the same as the value configured on the log host. Otherwise, the log host cannot receive system
information.
facility local-number: Specifies a logging facility from local0 to local7 for the log host. The default value
is local7. Logging facilities are used to mark different logging sources, and query and filer logs.
Usage guidelines
The info-center loghost command takes effect only after information center is enabled with the
info-center enable command.
The device supports up to four log hosts.
Examples
# Output logs to the log host 1.1.1.1.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1

info-center loghost source

Use info-center loghost source to specify the source IP address for output logs.
Use undo info-center loghost source to restore the default.
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
Default
The source IP address of output logs is the primary IP address of the matching route's egress interface.
66