Mirroring-Group Mirroring-Port (System View) - HP 6125XLG Command Reference Manual

mirroring-group mirroring-port (system view)

Use mirroring-group mirroring-port to configure source ports for a mirroring group.
Use undo mirroring-group mirroring-port to remove source ports from a mirroring group.
Syntax
mirroring-group group-id mirroring-port interface-list { both | inbound | outbound }
undo mirroring-group group-id mirroring-port interface-list
Default
No source port is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
Parameters
group-id: Number of the mirroring group, in the range of 1 to 4. The mirroring group specified by the
group-id argument must already exist.
interface-list: Source port list, containing one or more ports, in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] }&<1-8>. The interface-type
interface-number argument specifies an interface by its type and number. &<1-8> indicates that you can
specify up to eight interface-type interface-number [ to interface-type interface-number ] parameters.
When you use to to specify an interface range, the start and end interfaces must be of the same type on
the same device, and the end interface number must be equal to or greater than the start port number.
both: Mirrors both received and sent packets on the specified ports.
inbound: Mirrors only received packets on the specified ports.
outbound: Mirrors only sent packets on the specified ports.
Usage guidelines
You can configure source ports only for local mirroring groups or remote source groups but not for remote
destination groups.
Do not assign source ports to remote probe VLANs.
A port can serve as a source port for multiple mirroring groups, but the port cannot be a reflector port,
egress port, or monitor port at the same time.
Examples
# Create local mirroring group 1, configure Ten-GigabitEthernet 1/1/5 as a source port of the mirroring
group, and configure the mirroring group to monitor the bidirectional traffic of the port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 mirroring-port ten-gigabitethernet 1/1/5 both
# Create remote source group 2, configure Ten-GigabitEthernet 1/1/6 as a source port of the mirroring
group, and configure the mirroring group to monitor the bidirectional traffic of the port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
192