Dot1X Retry - HP 6125XLG Command Reference Manual

Examples
# Enable the 802.1X periodic online user re-authentication function on Ten-GigabitEthernet 1/1/6 and
set the periodic re-authentication interval to 1800 seconds.
<Sysname> system-view
[Sysname] dot1x timer reauth-period 1800
[Sysname] interface ten-gigabitethernet 1/1/6
[Sysname-Ten-GigabitEthernet1/1/6] dot1x re-authenticate
Related commands
display dot1x
•
dot1x timer
•

dot1x retry

Use dot1x retry to set the maximum number of attempts for sending an authentication request to a client.
Use undo dot1x retry to restore the default.
Syntax
dot1x retry max-retry-value
undo dot1x retry
Default
The maximum number of attempts that the device can send an authentication request to a client is two.
Views
System view
Predefined user roles
network-admin
Parameters
max-retry-value: Specifies the maximum number of attempts for sending an authentication request to a
client. The value range is 1 to 10.
Usage guidelines
After the network access device sends an authentication request to a client, if the device receives no
response from the client within the username request timeout timer (set with the dot1x timer tx-period
tx-period-value command for the EAP-Request/Identity packet) or the client timeout timer (set with the
dot1x timer supp-timeout supp-timeout-value command for the EAP-Request MD5 Challenge packet), the
device retransmits the authentication request. The network access device stops retransmitting the request,
if it has made the maximum number of request transmission attempts but still received no response.
Examples
# Set the maximum number of attempts for sending an authentication request to a client to 9.
<Sysname> system-view
[Sysname] dot1x retry 9
Related commands
• display dot1x
dot1x timer
•
96