HP 6125XLG Command Reference Manual page 253

Table 38 Command output
Field
Src Address
Dst Address
Inbound SPI
Outbound SPI
Status
# Display the number of IPsec tunnels.
<Sysname> display ipsec tunnel count
Total IPsec Tunnel Count: 2
# Display information about all IPsec tunnels.
<Sysname> display ipsec tunnel
Tunnel ID: 0
Status: active
Perfect forward secrecy:
SA's SPI:
outbound: 2000
inbound: 1000
outbound: 4000
inbound: 3000
Tunnel:
local address:
remote address:
Flow:
Tunnel ID: 1
Status: active
Perfect forward secrecy:
SA's SPI:
outbound: 6000
inbound: 5000
outbound: 8000
inbound: 7000
Tunnel:
local address: 1.2.3.1
remote address: 2.2.2.2
Flow:
Description
Source IP address of the IPsec tunnel.
For IPsec SAs created by using IPsec profiles, "–" is displayed in this field.
Destination IP address of the IPsec tunnel.
For IPsec SAs created by using IPsec profiles, "–" is displayed in this field.
Valid SPI in the inbound direction of the IPsec tunnel.
If the tunnel uses two security protocols, two SPIs in the inbound direction are
displayed in two lines.
Valid SPI in the outbound direction of the IPsec tunnel.
If the tunnel uses two security protocols, two SPIs in the outbound direction are
displayed in two lines.
Stateful failover status of the IPsec SA: active or backup.
Currently, "active" is displayed for all cases.
(0x000007d0)
(0x000003e8)
(0x00000fa0)
(0x00000bb8)
(0x00001770)
(0x00001388)
(0x00001f40)
(0x00001b58)
[AH]
[AH]
[ESP]
[ESP]
[AH]
[AH]
[ESP]
[ESP]
244