Queue - HP 6125G Command Reference Manual

Default level
2: System level
Parameters
table table-name: Specifies a name for the table.
Description
Use qos wred queue table to create a WRED table and enter WRED table view.
Use undo qos wred table to delete a WRED table.
By default, no WRED table is created.
A WRED table in use cannot be removed.
Related commands: qos wfq, qos wred enable, and display qos wred interface.
Examples
# Create an queue-based WRED table named queue-table1.
<Sysname> system-view
[Sysname] qos wred queue table queue-table1
[Sysname-wred-table-queue-table1]

queue

Syntax
queue queue-value [ drop-level drop-level ] low-limit low-limit high-limit high-limit [ discard-probability
discard-prob ]
undo queue { queue-value | all }
View
WRED table view
Default level
2: System level
Parameters
queue-value: Queue number, which ranges from 0 to 7.
drop-level drop-level: Drop level, which ranges from 0 to 2. If this argument is not specified, the
subsequent configuration takes effect on the packets in the queue regardless of the drop level.
low-limit low-limit: Specifies the lower threshold of the average queue length, which ranges from 0 to
8000 and defaults to 100.
high-limit high-limit: Specifies the upper threshold of the average queue length, which ranges from 0 to
8000, must be greater than the lower threshold, and defaults to 1000.
discard-probability discard-prob: Specifies the drop probability in percentage, which ranges from 0 to
100. When the average queue length is between the lower threshold and upper threshold, the switch
drops at the drop probability.
Description
Use queue to configure the queue-based WRED table.
Use undo queue to restore the default.
88