Qos Wfq Byte-Count - HP 6125G Command Reference Manual

Description
Use qos wfq to enable WFQ on a port.
Use undo qos wfq to restore the default queuing algorithm on a port.
The default queuing algorithm on a port is SP queuing.
You must enable WFQ before you can configure WFQ queuing parameters for a queue on an interface.
Examples
# Enable byte-count WFQ on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wfq byte-count

qos wfq byte-count

Syntax
qos wfq queue-id group 1 byte-count schedule-value
undo qos wfq queue-id group 1 byte-count
View
Interface view
Default level
2: System level
Parameters
queue-id: Specifies a queue by its ID, which ranges from 0 to 7.
group 1: Assigns a queue to the WFQ group.
byte-count schedule-value: Specifies a scheduling weight for the specified queue in byte-count WFQ
queuing. The scheduling weight ranges from 1 to 15.
Description
Use qos wfq byte-count to assign a queue to a WFQ group, with a certain scheduling weight, on an
interface that performs byte-count WFQ queuing.
Use undo qos wfq byte-count to restore the default on an interface that performs byte-count WFQ
queuing.
By default, the scheduling weights of queues 0 through 7 are all 1 on an interface that performs
byte-count WFQ queuing.
Before using this command on an interface, make sure that the interface is enabled with byte-count WFQ
queuing. Otherwise, the weight configuration does not take effect.
Related commands: display qos wfq interface and qos wfq.
Examples
# Enable byte-count WFQ on interface GigabitEthernet 1/0/1, and assign queue 0, with the scheduling
weight 10.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wfq byte-count
82