HP 6125G Command Reference Manual page 89

group 1: Assigns a queue to the WFQ group.
weight schedule-value: Specifies a scheduling weight for the specified queue. The scheduling weight
ranges from 1 to 15.
Description
Use qos wfq weight to assign a queue to a WFQ group, with a certain scheduling weight, on an
interface that performs packet-based WFQ queuing.
Use undo qos wfq weight to restore the default WFQ settings of a queue on an interface that performs
packet-based WFQ queuing.
By default, the scheduling weights of queues 0 through 7 are all 1 on an interface that performs
packet-based WFQ queuing.
Before configuring this command, make sure that the interface is enabled with packet-based WFQ
queuing. Otherwise, the weight configuration does not take effect.
Related commands: display qos wfq interface, qos bandwidth queue, and qos wfq.
Examples
# Enable packet-based WFQ on GigabitEthernet 1/0/1, and assign queue 0, with the scheduling
weight 10.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wfq weight
[Sysname-GigabitEthernet1/0/1] qos wfq 0 group 1 weight 10
84