Peer Dscp (Ipv6 Address Family View) - HP 6125G Command Reference Manual

Use undo peer description to remove the description information of a peer/peer group.
By default, no description information is configured for a peer (group).
You need create a peer/peer group before configuring a description for it.
Examples
# Configure the description for the peer group test as ISP1.
<Sysname] system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test description ISP1

peer dscp (IPv6 address family view)

Syntax
peer { ipv6-group-name | ipv6-address } dscp dscp-value
undo peer { ipv6-group-name | ipv6-address } dscp
View
IPv6 address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies the name of a peer group, a string of 1 to 47 characters.
Ipv6-address: Specifies the IPv6 address of a peer.
dscp-value: Specifies the DSCP value for IPv6 BGP packets, in the range of 0 to 63.
Description
Use peer dscp to set the DSCP value for IPv6 BGP packets sent to the specified IPv6 BGP peer or peer
group.
Use undo peer dscp to remove the configuration.
By default, the DSCP value in BGP packets is 48.
The IPv6 BGP peer or peer group you specified must have been created.
Examples
# In BGP view, set the DSCP value for IPv6 BGP packets sent to peer group test to 63.
<Sysname] system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test dscp 63
312