Stub (Ospf Area View) - HP 6125G Command Reference Manual

Based on its LSDB, an OSPF router calculates the shortest path tree with itself being the root, and uses it
to determine the next hop to a destination. Through adjusting the SPF calculation interval, you can protect
bandwidth and router resources from being over-consumed due to frequent network changes.
With this command configured, when network changes are not frequent, SPF calculation applies at the
minimum-interval. If network changes become frequent, the SPF calculation interval is incremented by the
incremental-interval each time a calculation happens, up to the maximum-interval.
Examples
# Configure the SPF calculation maximum interval as 10 seconds, minimum interval as 500 milliseconds
and incremental interval as 200 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] spf-schedule-interval 10 500 200

stub (OSPF area view)

Syntax
stub [ default-route-advertise-always | no-summary ] *
undo stub
View
OSPF area view
Default level
2: System level
Parameters
default-route-advertise-always: Usable only on a stub ABR. With this keyword configured, the ABR
advertises a default route in a Type-3 LSA into the stub area regardless of whether FULL-state neighbors
exist in the backbone area. Without this keyword, the ABR advertises a default route in a Type-3 LSA into
the stub area only when at least one FULL-state neighbor exists in the backbone area.
no-summary: Usable only on a stub ABR. With this keyword configured, the ABR advertises only a
default route in a Summary LSA into the stub area (such a stub area is a totally stub area).
Description
Use stub to configure an area as a stub area.
Use undo stub to remove the configuration.
No area is stub area by default.
To cancel the default-route-advertise-always or the no-summary configuration on the ABR, execute the
stub command again to overwrite it.
To configure an area as a stub area, all routers attached to it must be configured with this command.
Related commands: default-cost.
Examples
# Configure Area1 as a stub area.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
122