Removing The Media Card Reader - Dell OptiPlex 755 User Manual

1 data cable 2 power cable
5. Replace the computer cover (see
6. Enter system setup (see Entering System
7. Verify that your computer works correctly by running the Dell Diagnostics (see
Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.

Removing the Media Card Reader

1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the drive panel by sliding the drive release latch downward to open the panel, and then remove it from the hinges.
4. Disconnect the cable from the back of the media card reader.
1 media card reader
3 floppy drive connector (DSKT)
Replacing the Computer Cover).
Setup), and use the Diskette Drive option to enable your new floppy drive.
Begin.
Removing the Computer Cover).
2 drive release latch
Dell Diagnostics).