Dell OptiPlex 755 User Manual page 12

Specifies whether a Measured Virtual Machine Monitor (MVMM) can use additional hardware capabilities provided by Intel
Trusted Execution
Trusted Execution Technology. Default is Off.
Specifies whether a Virtual Appliance can use the additional hardware capabilities provided by Intel Embedded Information
Virtual Appliance
Technology. Default is Off.
Specifies whether the Virtual Appliance ACPI Configuration Interface is locked or unlocked. This option has no effect when
VA Config Lock
Virtual Appliance is disabled. Default is Unlocked.
Enables Intel® SpeedStep® for all supported processors in the computer. This setting changes the processor power
SpeedStep
consumption and frequency.
(Off default)
NOTE:
Limits the max value the processor standard CPUID function will support. Some operating systems won't complete installation
Limit CPUID Value
when the max CPUID function supported is greater than 3.
(Off default)
HDD Acoustic Mode (Bypass
default)
NOTE:
Changing the acoustics setting does not alter your hard drive image.
Security
When an administrator password is being used, allows the user access to modify system setup settings. Enter the administrator
Unlock Setup
password at the prompt to unlock system setup. If the correct password is not entered here, the user can view but not modify system
setup fields.
Displays the current status of your system setup program's password security feature and allows you to verify and assign a new admin
Admin Password
password.
(Not Set
default)
Displays the current status of the computer's system password security feature and allows a new system password to be assigned and
System Password
verified.
(Not Set
default)
Displays the current status of the hard drive's password security feature and allows a new hard drive password to be assigned and
SATA 0-n
verified.
Password
(Not Set
default)
Determines the interaction between the System password and the Admin password. Locked prevents a user without a valid Admin
Password
password from being able to modify the System password. Unlocked allows a user with a valid System password to modify the system
Changes
password.
(Unlocked
default)
When enabled and the switch installed, this option alerts the user, during the next computer start-up, that the computer cover has been
Chassis
opened. The settings are On, On-Silent (default setting), and Off.
Intrusion
(On-Silent
default)
Acknowledges and clears a chassis intrusion alert.
Intrusion
Detected
Enables or disables the Trusted Platform Module security device.
TPM Security
(Off default)
Activates or deactivates the Trusted Platform Module security device. The Clear option clears any data stored by a user that has
TPM Activation
previously activated and used TPM.
(Deactivate
default)
NOTE: In order to activate Trusted Platform Module, the TPM Security option must be set to On.
Enables or disables Execute Disable memory protection technology.
Execute Disable
(On default)
Enables or disables the BIOS interface of the optional Computrace service from Absolute Software. This optional monitoring service must
Computrace
be purchased separately.
(Deactivate
Activate permanently enables the BIOS-Computrace interface. Disable permanently disables the BIOS-Computrace interface. Deactivate
default)
temporarily deactivates the BIOS-Computrace interface.
NOTE: By activating service, you consent to transmission of data from your computer to the Computrace server.
Power Management
This option may not be available on your computer.
Quiet — The hard drive operates at its most quiet setting.
l
Performance — The hard drive operates at its maximum speed.
l
Bypass — Your computer does not test or change the current acoustics mode setting.
l
Suggested — The hard drive operates at the level suggested by the drive manufacturer.
l
Switching to performance mode may cause the drive to be noisier, but its performance is not affected.