Removing The Floppy Drive - Dell OptiPlex 755 User Manual

1 data cable 2 hard drive system board connector
9. Replace the computer cover (see
10. Enter system setup (see System
11. Exit system setup, and reboot the computer.
12. Partition and logically format your drive.
See the documentation for your operating system for instructions.
13. Test the hard drive by running the Dell Diagnostics (see
14. If the drive you just installed is the primary drive, install your operating system on the hard drive.
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.

Removing the Floppy Drive

1. Boot your computer and enter system setup (see
2. Follow the procedures in Before You
3. Remove the computer cover (see
4. Remove the drive panel by sliding the drive release latch downward to open the panel, and then remove it from the hinges.
5. Disconnect the power and data cables from the back of the floppy drive.
Replacing the Computer Cover).
Setup), and update the SATA port option under the Drives option list.
Dell Diagnostics).
Entering System
Begin.
Removing the Computer Cover).
3 power cable
Setup). Use the Diskette Drive option to disable the floppy drive.