Dell OptiPlex 755 User Manual page 45

or line-in connectors on the back panel.
15. If you installed a network adapter card and want to turn off the integrated network adapter:
a. Enter system setup, select Network Controller and change the setting to Off (see
b. Connect the network cable to the network adapter card's connectors. Do not connect the network cable to the integrated network connector on
the back panel of the computer.
NOTICE: If you disable the integrated network adapter, you will not have AMT functionality.
16. Install any drivers required for the card as described in the card documentation.
Removing a PCI Card From the Riser-Card Cage
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the riser-card cage:
a. Check any cables connected to cards through the back panel openings. Disconnect any cables that will not reach the riser-card cage once they
are removed from the computer.
b. Gently pull on the handle and lift the riser-card cage up and away from the computer.
1 riser-card cage
2 handle
4. Press in on the tab to raise the card-retention latch.
5. If necessary, disconnect any cables connected to the card.
6. Grasp the card by its top corners, and ease it out of its connector.
7. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets keep dust
and dirt out of your computer and maintain the airflow that cools your computer.
8. Lower the card-retention latch and press it into place.
9. Replace the riser-card cage:
a. Align the tabs in the side of the riser-card cage with the slots on the side of the computer, and slide the riser-card cage down into place.
b. Ensure that the riser cards are fully seated in the connectors on the system board.
Begin.
Removing the Computer Cover).
Entering System Setup).