Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card slot.
2. Slide the solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x2.5) that secures the solid-state drive to the system board.
Next steps
1. Install the
system-board
2. Install the stand.
3. Install the
bottom
cover.
4. Install the
back
cover.
5. Follow the procedure in
Media-card reader
Removing the media-card reader
Prerequisites
1. Follow the procedure in
2. Remove the
back
cover.
3. Remove the
bottom
cover.
4. Remove the stand.
5. Remove the
system-board
About this task
The following image indicates the location of the media-card reader and provides a visual representation of the removal
procedure.
32
Removing and installing components
shield.
After working inside your
Before working inside your
shield.
computer.
computer.