Dell OptiPlex 755 User Manual page 48

3. Gently lift the release tab on the card retention latch from the inside to pivot the latch open. Pivot the latch until it snaps into the open position.
4. Disconnect the PS/2 serial-port cable from the system board (see
5. Ease the PS/2 serial-port adapter bracket out of its retention slot.
6. If you are removing the adapter permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets keep dust
and dirt out of your computer and maintain the airflow that cools your computer.
7. Before you close the card retention mechanism, ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
l
8. Secure any remaining card(s) by closing the card retention latch and snapping it into place.
9. Replace the computer cover (see
Installing a PS/2 Serial Port Adapter in the Riser-Card Cage
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the riser-card cage:
a. Check any cables connected to cards through the back panel openings. Disconnect any cables that will not reach the riser-card cage once they
are removed from the computer.
b. Rotate the riser-card cage handle up and gently pull on the handle to lift the riser-card cage up and away from the computer.
System Board
Replacing the Computer Cover).
Begin.
Removing the Computer Cover).
Components).