System Setup - Toshiba RemoteEye II User Manual

System Setup

To access the RemotEye II via the web, enter the IP address of the RemotEye II in the
URL field of the browser and press Enter. If unable to access the RemotEye II due to
a firewall, contact the network administrator for information on bypassing the firewall
of the LAN.
The HTTP Security Control setting may also affect the user's ability to access the
RemotEye II. The HTTP Security Control setting may be set or viewed from: Main
Menu → ( 1) T IC RemotEye II Configuration →(2) Control Group → (7) HTTP
Security Control.
If the HTTP Security Control setting is Disabled, the user is granted read-only access.
If the HTTP Security Control is Enabled, any attempt to access RemotEye II pages
will be met with a request to enter a password. Once the password has been entered
in the user will be able to not only view the information, but make changes
accordingly. The password is the same as the Community Read/Write string (see Main
Menu → ( 1) T oshiba RemotEye II Configuration → ( 2) Control Group → (3)
Community Read/Write).
Once access to the RemotEye II is achieved, refer to this section for information on
how to use the web-based administration interface to monitor and maintain the
RemotEye II. This section also provides information on the built-in administrative
functions of the RemotEye II.
To prevent unauthorized users from configuring the RemotEye II via HTTP, the IP
address of the workstation must be entered in the RemotEye II SNMP Communities
with no access permissions (via RS232 or Telnet) or the SNMP/ HTTP Access
Control (via Web Browser) of the RemotEye II. Otherwise, the RemotEye II will
provide only read access to its parameters.
46