Upgrade Remoteye Ii - Toshiba RemoteEye II User Manual

Upgrade RemotEye II

General information
To be able to perform firmware upgrading, RemotEye II must be connected to the
same network as the workstation from which the upgrade file is to be sent. In the
RemotEye II make sure the TFTP Upgrade Control is enabled and that users have the
login string information and the Community Read/Write Password.
Hardware Setup
RemotEye II upgrade is accomplished through a network link. Follow these steps to
setup the hardware for RemotEye II upgrade:
Verify network cable connection to NETWORK port of RemotEye II.
Verify active link to LAN or Network.
For further information on the network connection, refer Making the Network
Connection on page 20
Tupgrade Menu Navigation
UPS List: Displays the addresses of the RemotEye II present in the local network.
Discover: Search for the RemotEye II on the local network.
Add: Lets you add the IP address of a RemotEye II to the UPS List manually.
Modify: Lets you modify the parameters of the RemotEye II selected in the UPS List.
Upgrade: Sends the program loaded with the Open button to the selected RemotEye II
of the UPS List.
Open: Open and load the new image file for upgrade.
Remove: Remove the selected RemotEye II from the UPS List.
Quit: Exit the program.
Note: You can simultaneously upgrade up to 6 RemotEye II on the network using the
Tupgrade.exe program
128