Snmp Settings - EnGenius ENH210 User Manual

11.3 SNMP Settings

Click on the SNMP Settings link under the Management menu. This is a networking
management protocol used to monitor network-attached devices. SNMP allows messages
[called protocol data units] to be sent to various parts of a network. Upon receiving these
messages, SNMP-compatible devices [called agents] return data stored in their Management
Information Databases.
SNMP Enable/Disable
Contact
Location
Community Name
Community Name
Trap Destination IP
Address
Trap Destination
Community Name
Save / Apply / Cancel
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 6.1 for more information.
Select the Radio button to Enable or Disable SNMP function.
Specify the contact details of the device.
Specify the location of the device.
Specify the password for access the SNMP community for read
only access.
Specify the password for access the SNMP community for read
and write access.
Specify the IP address that will receive the SNMP trap.
Specify the password of the SNMP trap community.
Press Save / Apply to confirm the changes or Cancel to return
previous settings.