EnGenius ENH210 User Manual page 58

Internet Connection
Type
Account Name
Domain Name
MTU
IP Address
IP Subnet Mask
Gateway IP Address
Primary DNS
Secondary DNS
Discard Ping on WAN
Accept / Cancel
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 6.1 for more information.
If the router's MTU is set too high, downstream packets will be fragmented. If
the router's MTU is set too low, the router will fragment packets unnecessarily and, in extreme
cases, may be unable to establish connections. In either case, network performance can suffer.
Select Static IP to begin configuration of the Static IP connection.
Specify Account Name that is provided by ISP.
Specify Domain Name that is provided by ISP.
Specify the Maximum Transmit Unit size. EnGenius recommends
that it remains in Auto.
Specify WAN port IP address.
Specify WAN IP Subnet Mask.
Specify WAN Gateway IP address.
Specify Primary DNS IP.
Specify Secondary DNS IP.
Place a check to Enable or Disable ping from WAN.
Press Accept to confirm the changes or Cancel to return
previous settings.