EnGenius ENH210 User Manual page 52

Aggregation
Wireless Traffic
Shaping
Incoming Traffic Limit
Outgoing Traffic Limit
Accept / Cancel
Please make note of the following:
1. Accept does not apply the changes – you must go to Status -> Save / Load to apply
the new settings. Please refer to Chapter 6.1 for more information.
2. Changing Wireless Advanced Settings may lower the wireless connection quality.
Please keep all settings as default unless you understand the modifications which you
have made.
increase performance by 10% during the data transmission. For
example, if the 802.11b/g's GI is 800μs, the short GI will be 400μs.
The shorter guard interval results in a higher packet collision rate
when the delay-spread of the channel exceeds the guard interval
or if timing synchronization between the transmitter and receiver
is not precise.
Aggregation is used to merge multiple packets together into a
large specified value. It is effective for scenarios with frequent
packets of small data size.
Place a check to enable Wireless Traffic Shaping function. This
function limits the throughput to each wireless client.
Specify the wireless transmission speed for incoming traffic.
Specify the wireless transmission speed for outgoing traffic.
Press Accept to confirm the changes or Cancel to return
previous settings.