System; Switching The Operation Mode - EnGenius ENH210 User Manual

7 System

7.1 Switching the Operation Mode

The ENH210 supports 4 modes: Access Point, Client Bridge, WDS Bridge, and Client Router. In
order to switch between the operating modes, please go to System -> Operation mode.
To begin, view System Properties under System Section.
 Device Name: Specify a name for the device. It is not the broadcast SSID; this will be
shown in SNMP management.
 Country/Region: Select a Country/Region to conform to local regulations.
 Operation Mode: Select an operation mode via a Radio Button.
Click Accept to confirm the changes.
Clicking Accept does not apply the changes – you must go to Status ->
Save / Load to apply the new settings. Please refer to Chapter 6.1 for more information.
If you would like to use Access Point with WDS Function mode, please select
Access Point Mode and then enable WDS function in the Wireless Network section. The
scenario requiring this functionality, WDS and AP, is rare.