Changing The Default Administrative Password - Cisco CVR100W Administration Manual

Introduction

Changing the Default Administrative Password

STEP 3
STEP 4
STEP 5
Changing the Default Administrative Password
Cisco CVR100W Wireless-N VPN Router Administration Guide
The CVR100W automatically changes its IP address to 10. 1 0. 1 0. 1 when its
NOTE
default IP address conflicts with another device in your network.
When the login page appears, choose the language that you prefer to use in the
utility, and then enter the username and password.
The default username is cisco. The default password is cisco. Both username and
password are case sensitive.
Click Log In. The Setup Wizard will now launch.
Follow the on-screen prompts to complete the initial configuration. See
the Setup Wizard for more information on completing the Setup Wizard
configuration.
For security reasons, you must change the password from its default setting at
your first login. Please write this password down for future reference. A blank
password is not recommended.
Passwords should not contain dictionary words from any language or be the
default password. They should contain a mixture of uppercase and lowercase
letters, numbers, and symbols. Passwords must be at least 8 but no more than 64
characters in length.
After the Setup Wizard is complete, the Connection Status page appears. See
Using the Connection Status Page
The administrative password protects your CVR100W from unauthorized access.
For security reasons, you must change the password from its default setting at
your first login.
You can change the default administrative password as instructed by the Setup
Wizard (see Running the Setup
Configuring Administrator Account Settings
Wizard without saving your settings at your first login by clicking Exit, the Change
Password window opens.
By default, the password strength enforcement is enabled on the CVR100W. The
Change Password window displays the minimum password complexity
requirements as follows:
for more information.
Wizard) or by following the instructions in the
section. If you exit the Setup
1
Running
16