Configuring Dhcpv6 Settings - Cisco CVR100W Administration Manual

Configuring Network
Configuring IPv6
STEP 3
STEP 1
STEP 2
Cisco CVR100W Wireless-N VPN Router Administration Guide
IPv6 Prefix Length
Click Save.

Configuring DHCPv6 Settings

To configure DHCPv6 settings:
Choose Networking > IPv6 Configuration > IPv6 LAN Configuration.
In the Server Settings (DHCPv6) area, enter the following information to
configure the DHCPv6 settings:
DHCP Status
Domain Name
Server Preference
Static DNS 1
Static DNS 2
Enter the IPv6 prefix length.
The IPv6 network (subnet) is identified by the initial
bits of the address called the prefix. By default, the
prefix is 64 bits long.
All hosts in the network have the identical initial bits for
their IPv6 address; you set the number of common
initial bits in the network's addresses in this field.
Check to enable the DHCPv6 server.
If enabled, the CVR100W assigns an IP address within
the specified range plus additional specified
information to any LAN endpoint that requests DHCP-
served addresses.
Enter the domain name of the DHCPv6 server.
Enter the server preference level of this DHCP server.
DHCP advertise messages with the highest server
preference value to a LAN host are preferred over
other DHCP server advertise messages.
The default is 255.
Enter the IPv6 address of the primary DNS server on
the ISP's IPv6 network.
Enter the IPv6 address of the secondary DNS server
on the ISP's IPv6 network.
3
57