Configuring Wireless Network Settings - Cisco CVR100W Administration Manual

Configuring Wireless Network
Configuring Basic Wireless Settings
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 1
STEP 2
Cisco CVR100W Wireless-N VPN Router Administration Guide
B/G-Mixed Choose this option if you have Wireless-B and Wireless-G
devices in your network.
G/N-Mixed Choose this option if you have Wireless-G and Wireless-N
devices in your network.
In the Wireless Band Selection field, choose either 20MHz or 20/40MHz as the
wireless bandwidth on your network.
In the Wireless Channel field, choose the wireless channel from the drop-down
menu or choose Auto to let the system determine the optimal channel to use
based on the environmental noise levels for the available channels.
In the AP Management VLAN field, choose VLAN 1 if you are using the default
settings.
If you create additional VLANs, choose a value that corresponds with the VLAN
configured on other switches in the network. This is done for security purposes.
You might need to change the management VLAN to limit access to the
CVR100W's Configuration Utility.
(Optional) In the U-APSD (WMM Power Save) field, check Enable to enable the
Unscheduled Automatic Power Save Delivery (U-APSD) feature, also referred to as
WMM Power Save, that allows the radio to conserve power.
U-APSD is a power saving scheme optimized for real-time applications, such as
VoIP, transferring full-duplex data over WLAN. By classifying outgoing IP traffic as
Voice data, these types of applications can increase battery life by approximately
25 percent and minimize transmit delays.
Click Save.

Configuring Wireless Network Settings

The Wireless Table in the Basic Settings page lists the settings of the four
wireless networks supported on the CVR100W.
To configure the settings for a wireless network:
Check the box for the network that you want to configure, and click the Edit button.
Configure these settings:
4
69