Configuring Wps - Cisco CVR100W Administration Manual

Configuring Wireless Network

Configuring WPS

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Configuring WPS
STEP 1
STEP 2
STEP 3
STEP 4
Cisco CVR100W Wireless-N VPN Router Administration Guide
To configure a WDS:
Choose Wireless > WDS.
Check Allow wireless signal to be repeated by a repeater to enable WDS.
To manually enter the MAC address of a repeater, click the Manual radio button.
Enter the MAC addresses of up to three access points to use as repeaters in the
MAC 1, MAC 2, MAC 3 fields.
(Optional) Click the Show Site Survey button.
The Available Networks table lists the available wireless network access points.
• (Optional) Click the Refresh button to update the entries in the table.
• In the Available Networks Table, select up to three access points to use as
repeaters.
• To add the MAC addresses of the selected access points to the MAC fields
below the table, click Connect.
Click Save.
You can configure WPS on the CVR100W to allow WPS-enabled devices to more
easily connect to the wireless network.
To enable WPS on your CVR100W:
Choose Wireless > WPS.
From the SSID drop-down menu, choose the wireless network on which the WPS
settings are applied.
In the WPS field, check Enable to enable WPS. To disable WPS, uncheck the box.
Use one of the following methods to configure WPS on client devices:
• If your client device has a WPS button, first click the WPS button on the client
device, and then click the WPS button on this page.
4
83