Configuring Basic Vpn Setup; Viewing Default Vpn Settings - Cisco CVR100W Administration Manual

Configuring VPN

Configuring Basic VPN Setup

Configuring Basic VPN Setup
STEP 1
STEP 2
Cisco CVR100W Wireless-N VPN Router Administration Guide
The CVR100W supports site-to-site VPN for a single gateway-to-gateway VPN
tunnel. In this configuration, the CVR100W creates a secure connection to another
VPN-enabled router. For example, you can configure the CVR100W at a branch site
to connect to the router at the corporate site, so that the branch site can securely
access the corporate network. You could have a router like the Cisco RV220W that
supports ten site-to-site VPN tunnels and have a CVR100W at each remote site to
provide secure connectivity.

Viewing Default VPN Settings

The basic VPN setup sets most parameters to defaults as proposed by the VPN
Consortium (VPNC), and assumes a pre-shared key, which greatly simplifies the
setup.
To view the default VPN settings on your CVR100W:
Choose VPN > Basic VPN Setup.
Click View Default Settings.
The following default VPN settings are displayed:
Basic VPN Setup Default Values for IKE
Exchange Mode
Local WAN (Internet)
ID
Remote WAN
(Internet) ID
Encryption Algorithm
Authentication
Algorithm
Authentication
Method
Main
Local WAN (Internet) IP Address
Remote WAN (Internet) IP Address
AES-128
SHA-1
Pre-Shared Key
6
101