Snmp-Server Community Ipaddr; Snmp-Server Community Ipmask - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches

snmp-server community ipaddr

Use this command to set a client IP address for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP mask
value to denote a range of IP addresses from which SNMP clients might use that community to
access the device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is
ANDed with the mask to determine the range of allowed client IP addresses. The name is the
applicable community name.
Default 0.0.0.0
Format
snmp-server community ipaddr <ipaddr> <name>
Mode Global Config
no snmp-server community ipaddr
Use this command to set a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Format
no snmp-server community ipaddr <name>
Mode Global Config

snmp-server community ipmask

Use this command to set a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP address value to
denote a range of IP addresses from which SNMP clients might use that community to access the
device. A value of 255.255.255.255 will allow access from only one station, and will use that
machine's IP address for the client IP address. A value of 0.0.0.0 will allow access from any IP
address. The name is the applicable community name.
Default 0.0.0.0
Format
snmp-server community ipmask <ipmask> <name>
Mode Global Config
no snmp-server community ipmask
Use this command to set a client IP mask for an SNMP community to 0.0.0.0. The name is the
applicable community name. The community name might be up to 16 alphanumeric characters.
Format
no snmp-server community ipmask <name>
Mode Global Config
Management Commands
542