Set Gvrp Interfacemode; Show Gvrp Configuration - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches

set gvrp interfacemode

This command enables GVRP on a single port (Interface Config mode) or all ports (Global Config
mode).
Default disabled
Format
set gvrp interfacemode
Mode • Interface Config
• Global Config
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global Config
mode). If GVRP is disabled, Join Time, Leave Time, and Leave All Time have no effect.
Format
no set gvrp interfacemode
Mode • Interface Config
• Global Config

show gvrp configuration

This command displays Generic Attributes Registration Protocol (GARP) information for one or all
interfaces.
Format
show gvrp configuration {<slot/port> | all}
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Join Timer The interval between the transmission of GARP PDUs registering (or re-registering)
membership for an attribute. Current attributes are a VLAN or multicast group. There is an
instance of this timer on a per-Port, per-GARP participant basis. Permissible values are
10–100 centiseconds (0.1 to 1.0 seconds). The factory default is 20 centiseconds (0.2
seconds). The finest granularity of specification is one centisecond (0.01 seconds).
Leave Timer The period of time to wait after receiving an unregister request for an attribute before
deleting the attribute. Current attributes are a VLAN or multicast group. This may be
considered a buffer time for another station to assert registration for the same attribute in
order to maintain uninterrupted service. There is an instance of this timer on a per-Port,
per-GARP participant basis. Permissible values are 20–600 centiseconds (0.2 to 6.0
seconds). The factory default is 60 centiseconds (0.6 seconds).
Switching Commands
69