Remote Program (Cmd + 4 + 3); Description; For Systems Without A Phone Number - Bosch D1265 Owner's Manual

6. When the transmission is complete the keypad
shows Report sent for 5 sec.
If the Exit button is pressed before 5 sec
have elapsed, idle text is shown.
The display returns to idle text.
7. If the test (or status) report does not successfully
transmit to the central station, the keypad might
sound a trouble tone and display Comm Fail
Route Grp# (# = 1-4) after numerous
unsuccessful attempts.
Bosch Security Systems, Inc. | 9/10 | F01U169130-02
D1265 | Owner's Manual | Part III: Advanced Commands

Remote Program (CMD + 4 + 3)

Description

This function allows the user to initiate Remote
Programming Software (RPS) sessions. When the
phone is ringing at the control panel, the user initiates
this function to have the control panel seize the line.
Your security company can remotely program your
security system using the telephone line to which your
control panel is connected. Typical remote
programming functions include: changing personal
passcodes, changing entry/exit delays, resetting the
system clock/calendar, and adding/deleting system
arming commands.
Your security company might ask you to follow the
steps below to begin a remote programming session.
The time it takes to program the control panel is
dependent on the number of changes made to the
program.
You'll notice that two sets of procedures are presented.
The one you use depends upon whether your system
has a pre-programmed telephone number in its
memory.
 My system does not have the RPS phone or
the RPS network configured.

For systems without a phone number

1. Ensure the display shows disarmed idle text.
2. Call this phone number:
This number is designated for the RPS.
You must make the call using the telephone
located at:
___________________________
3. Identify yourself and your premises (account
number, name, address, etc.) and advise the
operator of the services you wish to have
performed. When the operator instructs you,
proceed to Steps 4 through 6.
4. Press the CMD button. The display shows
*System Command*.
5. Press the 4 button then the 3 button.
6. Advance the menu (if necessary) and select the
Allow Answer option.
35