Move To Area (Cmd + 5 + 0); Turning On The System; Turning On Selected Areas - Bosch D1265 Owner's Manual

D1265 | Owner's Manual | Part IV: Multi-Area Use

Move To Area (CMD + 5 + 0)

With this function you can perform tasks in an area
other than the one you're in without having to
physically go to that area. Your access to other areas is
limited by the scope of the keypad and your authority
level. For example, if your passcode gives you
authority to all areas supported by the control panel,
but the keypad you're working with is limited in scope
to areas 1 and 2, then you only can move to either area
1 or area 2.
Upon moving to another area, the range of tasks you
might perform depends upon the keypad you're
working with. Once you have performed a task (such
as Turning the Area On), the keypad reverts back to its
programmed area after 10 sec. Thus only one task can
be performed in another area at a time.
1. Ensure your keypad shows idle disarmed text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 5 button and then the 0 button.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the Move To Area
button, press it.
4. You might be prompted for your passcode. If so,
enter your passcode and press the ENTER button.
It appears on the display as asterisks (*).
The Exit button quits this function and return to
idle text.
5. The keypad shows the Area Name Text of each
area that falls within the scope of the keypad and
authority level of the user, if applicable.
62
If the user's authority level will not permit
access to a certain area and that area is
not within the scope of the keypad, or the
area is not enabled, it will not appear in
the display.
If the area you wish to move to will not appear
in this list, press the Next button to display
additional areas.
To select an area, simply press the button
corresponding to the Area Name.
6. Moving to...AREA 1 WAREHOUSE shows
briefly, and then the text of the area you have
moved to is shown (AREA 1 WAREHOUSE is
used as an example here).
7. You are now able to perform tasks in this area.
The number of areas to which you can move is
limited by the scope of the keypad.
8. When you have completed all tasks in the area
you have moved to, simply allow the keypad to
time-out and revert to the area from which you
started or enter the Move to Area function
again.

Turning On the System

Turning on Selected Areas

Areas covered in the scope of the keypad can be
armed individually by accessing the Master Arm
function through the menu.
1. Press the Menu button to enter the function list.
2. Press the Next button repeatedly until you
reach the Master Arm button, and then press
it.
3. You might be prompted for your passcode. It
appears on the display as asterisks (*).
Bosch Security Systems, Inc. | 9/10 | F01U169130-02