Special Alerts (Cmd + 7, Cmd + 9); Description; Using Cmd 7 - Bosch D1265 User Manual

D1265 | User's Guide | Part II: System Commands
13. The display prompts the user to exit the area
and starts counting down # seconds to arm the
system.
# is the number of seconds remaining in the
countdown.
14. When exit delay time expires and the system
turns on, the display shows:
15. To disarm, enter your personal passcode and
press ENTER.
24

Special Alerts (CMD + 7, CMD + 9)

Description

Commands 7 and 9 can be programmed to respond to
specific situations that might need immediate attention.
They might also be used to send a silent alarm to your
security company without sounding an alarm signal on
the premises. Check with your security company for
the options they offer.

Using CMD 7

1. Ensure your keypad shows idle text.
2. Press the CMD button. The display shows
*System Command*.
3. Press the 7 button.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the User Command 7
button, press it.
4. Your Command 7 special alert has been
programmed to:
 notify your alarm company
ring a bell on your premises

 display at your keypad
Description:
_________________________________________
_________________________________________
_________________________________________
Bosch Security Systems, Inc. | 9/10 | F01U169131-02