Send Report (Cmd + 4+1 Or 4+2); Description; Using Send Report - Bosch D1265 Owner's Manual

D1265 | Owner's Manual | Part III: Advanced Commands
No additional points indicates that there are
no more points that can be bypassed.
If an unbypassed point is entered, an error tone
will sound and a warning will be displayed.
The display returns to idle text.
7. If you are attempting to unbypass a 24-Hour or
Fire Point that is still faulted, the keypad shows
Cannot unbypass 24hr faulted points.
34

Send Report (CMD + 4+1 or 4+2)

Description

This function tests the communication link between
your security system and your security company. It is
an important part of maintaining a high level of
security for your property.
Two types of test reports can be sent. The first type of
report is a simple test report (Command 41). The
second type of report is a status report (Command 42).
This status report indicates the current condition of
your system.

Using Send Report

1. Always call your security company before
sending a test report.
2. Ensure the display shows disarmed idle text.
3. Press the CMD button. The display shows
*System Command*.
4. Press the 4 button then the 1 button to send a
test report.
Press the 4 button then the 2 button to send a
status report.
If you prefer, you might use the function
list in place of Steps 3 and 4 to initiate
this function.
Press the Menu button to enter the
function list.
Press the Next button repeatedly.
When you reach the Send Report button,
press it.
Another menu appears allowing for the
selection of sending a test report (Test
Rpt) or a status report (Status Rpt).
Press either button.
5. The keypad shows Sending report... Please
wait... until the report is transmitted to the
security company.
Bosch Security Systems, Inc. | 9/10 | F01U169130-02