DS7446KP | User Guide | 11.0 Optional Commands
6. Press [Bypass].
You can now enter the telephone number that all incoming calls are
forwarded to when you turn your system off. This number can be the
number for the telephone line that your system is connected to. Refer
to Table 17 on page 33 for special key functions.
7. Press [Bypass] again after all digits are entered.
8. Press and hold [# Command] to exit this command.
9. Press [# Command][8][2] to turn Auto Forward on.
10. Press [# Command] to exit this function.
11.8
Enable Keypad
PIN Entry
Extinguish Mode is a programming option that is set by your alarm
company. If it is programmed, then, after 30 sec of no activity, your
keypad's display shows one of the following conditions:
Blank display
The date and time on the top line, and custom text on the bottom line
Only the Power LED remains on.
Enter your PIN to turn on the keypad's display.
If your system was turned on or is in alarm, it remains on or in alarm until
you enter your PIN again.
To manually start Extinguish Mode, exit a command and press
[# Command] twice. You are now logged out.
11.9
Remote Program
[# Command][4][3]
Use this command to connect to your alarm company's PC for remote
programming of your system.
Only use this command when directed by your alarm company.
34
Bosch Security Systems | 12/04 | 4998149924B