Bosch D1265 Owner's Manual page 56

D1265 | Owner's Manual | Part III: Advanced Commands
4. When the display shows ### points remain to
be tested you can begin. (### is the number of
points).
Test each point by first activating the detection
device to fault the point.
If you know the point number, you can
enter it by pressing its number button and
then the ENTER button.
The display changes to show the point
that was entered. If the point is invalid the
message "Invalid Point" or "This is not a
valid walk point" appears.
5. As you fault each point, your keypad shows the
point text for 60 sec and ring the fire sounders
for 2 sec. This verifies that the detection device
is working properly. Your system automatically
resets smoke detectors.

When a resettable point (such as a smoke
detector) is faulted, the display shows
Sensors...resetting...please wait... for 5 sec.
During this time power is removed from smoke
power relays.

Faulting a point more than once will not
increment the test count. However, the keypad
emits a brief tone and shows the point text each
time you fault the point allowing you to test
multiple devices assigned to one point.
6. When the point has been tested, the display
changes to show SMOKE DETECTOR tested.
56
7. During the Fire Test you might want to refer to
the points that remain untested by pressing the
View untested pts button.
The display shows ### pts untested.
Press the Point information button to see
information about specific points that have not
yet been tested.
The display changes to show the information
for that point.
Move through this list by pressing the Next
Point button.
Press the Exit button to return to the ###
points remain to be tested before continuing
the Fire Test.
8. When all 24-hour points have been tested, 0
points remain to be tested is shown.
Press the Exit button.
The display momentarily shows All points
have been tested before returning to idle text.
Bosch Security Systems, Inc. | 9/10 | F01U169130-02