Wps - ZyXEL Communications NBG-419N v2 User Manual

Chapter 7 Easy Mode

7.6.7 WPS

Use this screen to add a wireless station to the network using WPS. Click WPS in the Wireless
Security to open the following screen.
Figure 42 Wireless Security: WPS
The following table describes the labels in this screen.
Table 27 Wireless Security: WPS
LABEL
Wireless
Security
WPS
Register
Exit
60
DESCRIPTION
Click this to go back to the Wireless Security screen.
Create a secure wireless network simply by pressing a button.
The Router scans for a WPS-enabled device within the range and performs wireless security
information synchronization.
Note: After you click the WPS button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have
to press these buttons on both device and the wireless station again after the first 2
minutes.
Create a secure wireless network simply by entering a wireless client's PIN (Personal
Identification Number) in the Router's interface and pushing this button.
Type the same PIN number generated in the wireless station's utility. Then click Register to
associate to each other and perform the wireless security information synchronization.
Click Exit to close this screen.
NBG-419N v2 User's Guide