Resetting The Router To Its Factory Defaults; Wireless Router/Ap Troubleshooting - ZyXEL Communications NBG-419N v2 User Manual

• Check the settings for QoS. If it is disabled, you might consider activating it. If it is enabled, you
might consider raising or lowering the priority for some applications.

26.4 Resetting the Router to Its Factory Defaults

If you reset the Router, you lose all of the changes you have made. The Router re-loads its default
settings, and the password resets to 1234. You have to make all of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the Router,
Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the Router.
2
Press the RESET button for longer than five seconds to set the Router back to its factory-default
3
configurations.
If the Router restarts automatically, wait for the Router to finish restarting, and log in to the Web
Configurator. The password is "1234".
If the Router does not restart automatically, disconnect and reconnect the Router's power. Then,
follow the directions above again.

26.5 Wireless Router/AP Troubleshooting

I cannot access the Router or ping any computer from the WLAN (wireless AP or router).
Make sure the wireless LAN is enabled on the Router
1
Make sure the wireless adapter on the wireless station is working properly.
2
Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports
3
the same wireless standard as the Router.
Make sure your computer (with a wireless adapter installed) is within the transmission range of the
4
Router.
Check that both the Router and your wireless station are using the same wireless and wireless
5
security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the Router.
6
NBG-419N v2 User's Guide
Chapter 26 Troubleshooting
193