Setting Your Router To Wisp Mode; Accessing The Web Configurator In Wisp Mode - ZyXEL Communications NBG-419N v2 User Manual

10.3.1 Setting your Router to WISP Mode

Log into the Web Configurator if you haven't already. See the Quick start Guide for instructions on
1
how to do this.
To set your Router to AP Mode, go to Maintenance > Sys OP Mode > General and select WISP
2
Mode.
Figure 54 Changing to WISP mode
Note: You have to log in to the Web Configurator again when you change modes.As soon
as you do, your Router is already in WISP mode.
When you select WISP Mode, the following pop-up message window appears.
3
Figure 55 Pop up window for WISP mode
Click OK. The Web Configurator refreshes once the change to WISP mode is successful.

10.3.2 Accessing the Web Configurator in WISP Mode

To login to Web Configurator in WISP mode, do the following:
Connect your computer to the LAN port of the Router.
1
The default IP address of the Router is "192.168.1.1". If you did not change this, you can use the
2
same IP address in WISP mode. Open a web browser such as Internet Explorer and type
"192.168.1.1" as the web address in your web browser.
If you changed the IP address of your Router while in Router Mode, use this IP address in WISP
mode. The WISP mode IP address is always the same as the Router mode IP adderss.
NBG-419N v2 User's Guide
Chapter 10 WISP Mode
77