ZyXEL Communications NBG-419N v2 User Manual page 19

If using screw anchors, drill two holes for the screw anchors into the wall. Push the
3
anchors into the full depth of the holes, then insert the screws into the anchors. Do not
insert the screws all the way in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not
insert the screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the Router with the
4
connection cables.
Align the holes on the back of the Router with the screws on the wall. Hang the Router on
5
the screws.
Figure 2 Wall Mounting Example
NBG-419N v2 User's Guide
Chapter 1 Getting to Know Your Router
19