Resetting The Nbg6604 To Its Factory Defaults; Wireless Connections - ZyXEL Communications NBG6604 User Manual

15.5 Resetting the NBG6604 to Its Factory Defaults

If you reset the NBG6604, you lose all of the changes you have made. The NBG6604 re-loads its default
settings, and the password resets to 1234. You have to make all of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the NBG6604:
Make sure the power LED is on.
1
Press the RESET button for one to four seconds to restart/reboot the NBG6604.
2
Press the RESET button for longer than five seconds to set the NBG6604 back to its factory-default
3
configurations.
If the NBG6604 restarts automatically, wait for the NBG6604 to finish restarting, and log in to the Web
Configurator. The password is "1234".
If the NBG6604 does not restart automatically, disconnect and reconnect the NBG6604's power. Then,
follow the directions above again.

15.6 Wireless Connections

I cannot access the NBG6604 or ping any computer from the WLAN.
Make sure the wireless LAN is enabled on the NBG6604.
1
Make sure the wireless adapter on your computer is working properly.
2
Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports the
3
same wireless standard as the NBG6604.
Make sure your computer (with a wireless adapter installed) is within the transmission range of the
4
NBG6604.
Check that both the NBG6604 and the wireless adapter on your computer are using the same wireless
5
and wireless security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the NBG6604.
6
Make sure you allow the NBG6604 to be remotely accessed through the WLAN interface. Check your
7
remote management settings.
• See the chapter on
Chapter 15 Troubleshooting
Wireless LAN in the User's Guide for more information.
NBG6604 User's Guide
105