To Remove The Backplane Assembly From The Acquisition Assemblies - Agilent Technologies Infiniium 90000 A Service Manual

Chapter 5: Replacing Assemblies

To remove the backplane assembly from the acquisition assemblies

To remove the backplane assembly from the acquisition assemblies
Remove the entire acquisition/backplane assembly as described in the previous
1
section.
Remove the four Torx T20 screws (two per acquisition assembly) on the side of the
2
backplane assembly (Figure 5-37).
Figure 5-37
Gently pry on the sheet metal portions to separate the backplane assembly from each
3
of the acquisition assemblies.
Remove the Torx T10 screws to remove each of the boards from their respective
4
subassembly chassis (Figure 5-38).
Figure 5-38
To reassemble the backplane/acquisition assembly, reverse these instructions.
5
112