Step 2. Remove The Front Panel Assembly - Agilent Technologies N5230-60102 Installation Note

Step 2. Remove the Front Panel Assembly

Refer to Figure 3 for this procedure.
1. With a T-10 TORX driver, remove the eight screws (item
Before removing the front panel from the analyzer, lift and support the front of
CAUTION
the analyzer chassis.
2. Slide the front panel over the test port connectors.
3. Disconnect the front panel interface ribbon cable (item
from the analyzer.
Figure 3 Front Panel Assembly Removal
The figure above shows the N5230A front panel and floppy disk drive. The
NOTE
N5230C front panel has a slightly different appearance and does not
include a floppy disk drive.
8
①
) from the sides of the frame.
②
). The front panel is now free
Installation Note N5230-90004