Agilent Technologies Infiniium 90000 A Service Manual page 2

Agilent Infiniium 90000 A-Series Oscilloscopes at a Glance
Ease of use with high performance
The Agilent Infiniium 90000 A-Series
oscilloscopes combine unprecedented ease-of-
use with high-performance digitizing
oscilloscope functionality to simplify your design
and analysis measurement tasks.
• Traditional oscilloscope front-panel
interface provides direct access to the
controls needed for most troubleshooting
tasks.
• Graphical user interface with menus,
windows, dialogs, and toolbars provides
easy access to dozens of configuration and
analysis tools, ensuring you can set up and
make the most complex measurements.
• All models offer 40 GSa/s sampling rate on all
four channels.
• Models with bandwidths from 2.5 GHz to
13 GHz.
Display shows waveforms and graphical
user interface
• Graphical interface allows direct interaction
with waveforms, including drag-and-drop
positioning and instant waveform zoom.
• Touchscreen display allows oscilloscope
operation without an external pointing
device.
• Waveforms displayed in color, making
correlation easy.
• Current configuration parameters displayed
near the waveform display and are color-
coded to make identification easy.
• Graphical interface menus and toolbars
simplify complex measurement setups.
Horizontal controls set sweep speed and
position
• Main sweep speeds from 5 ps/div to 20 s/div.
• Zoom mode is from 1 ps/div to main time base
setting.
• Intensified waveforms on main sweep
window make it easy to see what will appear
in the zoom window.
2
Acquisition and general controls start and stop
the scope and do basic setup
• Run and stop controls for continuous or single
acquisitions.
• Clear display before one or more
acquisitions.
• Default setup and Autoscale set initial
configuration.
Hard disk drive and USB 2.0 port for saving and
restoring setups and measurement results
• Store measurement displays for inclusion in
reports and test setup guides.
• Store oscilloscope setups to repeat tests
another time.
• Hard disk stores oscilloscope operating
system.
Trigger setup controls set mode and basic
parameters
• Select Edge, Glitch, or Advanced Modes.
• Choose input source and slope.
• Use graphical user interface to simplify
configuration of pattern, state, delay, and
violation trigger modes.
• Use auxiliary trigger to increase triggering
flexibility.
Vertical controls set attenuation, and
position
• Input attenuation adjustable from 1 mV/div to
1 V/div.
• Color-coded knobs make it easy to find the
controls that affect each waveform.
Marker and quick measurements help
measure waveform parameters
• Waveform markers A and B to check voltage
or Δ-time at any point on the displayed
waveform.