Standard Accessories; Maintaining The Cash Register - Olivetti ECR 2200 Instructions Manual

Unpac Unpac king and Setting Up the Cash Reg king and Setting Up the Cash Reg
Unpacking and Setting Up the Cash Reg Unpac Unpac king and Setting Up the Cash Reg king and Setting Up the Cash Register
NOTE: Please read this section carefully before attempting to program
the cash register or perform sales transactions.
As soon as you receive the cash register, open its shipping carton and
carefully withdraw each component. Make sure that the cash register
and all of its accessories, listed in the section entitled Standard
Accessories, are present in order to setup the cash register by following
these guidelines:
1. Place the cash register on a level, stable, vibration-free and dust-
free surface. Make sure it is near a grounded power outlet.
2. Plug the cash register into a grounded power outlet.
3. Insert the batteries as explained in the section entitled Inserting/
Replacing Batteries. Do not install the batteries unless the cash
register is plugged in.
4. Load the paper tape as explained in the section entitled Loading
Paper.
5. Set the desired program options as explained in the section Cash
Register Programming.
6. Once the desired program options have been programmed, set the
control switch to the R1 (journal record) or R2 (customer receipt)
position and you are ready to work with the cash register.
ister ister Maintaining the Cash Reg Maintaining the Cash Reg
ister ister Maintaining the Cash Reg

Maintaining the Cash Register

Maintaining the Cash Reg
Provided below is information on how to maintain your cash register.
NOTE: Before cleaning the cash register, make sure it is powered off
and/or unplugged from the wall outlet. Before unplugging the
cash register from the wall outlet, make sure that four charged
AA standard backup batteries are installed in the battery
compartment. All data stored in memory will be cancelled if
you unplug the cash register from the electrical wall outlet
without back-up battery supply.
1. Keep all liquids away from the cash register so as to avoid spills
which could damage the electronic components.
2. To clean the cash register firstly turn it off and/or unplug it from the
wall outlet (be sure the back-up batteries are installed), then use
just a damp cloth. Do not use corrosive substances such as solvents,
alcohol, petrol, or abrasive components.
3. If the cash register is stored in extreme hot or cold temperatures
(below 32 degrees or above 104 degrees Fahrenheit), allow the
temperature inside the cash register to reach room temperature
before turning it on.
4. DO NOT attempt to pull the paper tape when the cash register is
printing or when you are loading paper. Always use the [Feed] key
to feed paper. Pulling the paper tape could damage the print
mechanism.
ister ister
ister ister
3