Olivetti ECR 2200 Instructions Manual page 30

Pr Pr Pr Pr Printing an inting an inting an All PLU Dump Repor All PLU Dump Repor All PLU Dump Report t t t t
inting an inting an All PLU Dump Repor All PLU Dump Repor
Proceed as follows to print a PLU report:
1. Slide the control switch to the PRG position.
2. Press the [PLU] key to print the list.
3. Slide the control switch to the OFF position to exit the program
mode.
Shown below is an example PLU dump report.
PLU number
Department
the PLU is
linked to
Pr Pr Pr Pr Programming a Manager P ogramming a Manager P ogramming a Manager P
ogramming a Manager P ogramming a Manager Passw
You can define a manager password to prevent unauthorized access to
the machine's programming mode (PRG) and Z mode. Since the
management reports taken in the Z mode reset transaction totals to
zero, a management password prevents the accidental resetting of these
totals by unauthorized personnel.
Defining the PRG and Z Mode Manager P Def Def Def Def ining the PRG and Z Mode Manager Passw ining the PRG and Z Mode Manager P ining the PRG and Z Mode Manager P ining the PRG and Z Mode Manager P
Proceed as follows to define a manager password that grants access to
the PRG and Z modes:
1. Slide the control switch to the PRG position.
Fixed PLU
programming status
2. Type your 4-digit manager password and then press the [Charge]
key. The password entered is displayed and printed.
Price with
associated VAT
NOTE: If you define a manager password of 0000, the password
Example: Define manager password 9876 for the PRG and Z modes.
Type/Press:
[9876] + [Charge]
PLU price with
no VAT
NOTE: If you set a PRG and Z mode manager password, you will not
Open PLU
programming status
Clear Clear Clearing the PRG and Z Mode Manager P
Clear Clear
Proceed as follows to clear the manager password that grants access
to the PRG and Z modes:
1. Slide the control switch to the PRG position.
2. Type [0] + [0] + [0] + [0] and press the [Charge] key.
security protection feature will not work.
be able to alter your program or print your management reports
until the correct password is entered. If you attempt to make
changes to the machine's configuration or to print a Z manage-
ment report, the message "SEC Code" is displayed prompting
you to enter the password.
ing the PRG and Z Mode Manager Passw ing the PRG and Z Mode Manager P ing the PRG and Z Mode Manager P
ing the PRG and Z Mode Manager P
assw asswor or or or ord d d d d assw
assw
asswor or or or ord d d d d assw assw assw
asswor or or or ord d d d d assw assw
assw
23